Hozelock EASYCLEAR 3000, Руководство пользователя

Страница: 6 / 12

occurs, switch off the power at the
mains supply to the unit. If it is the
pump that has activated the Overload
Protection, check for the cause (it is
usually debris blocking the inlet of the
pump or obstructing the impeller).
Remove the obstruction and wait 15
minutes for the unit to cool down and.
Then switch it on again.
If it is the UV lamp that is activating
the Overload Protection (pump is still
running but UV lamp keeps going out
after running for a short time), please
contact Hozelock Consumer Services
Helpline on +44 (0)121 313 1122.
NOTE: YOU MUST SWITCH OFF THE
MAINS SUPPLY BEFORE THE UNIT WILL
RESET.
Keep the filter working 24 hours a day.
Ideally it should run all year round, but
at least throughout the fish-feeding
season, (i.e. until the water
temperature falls below 10°C and the
fish stop feeding). In winter, operating
the unit will maintain a basic level of
useful bacteria in the Biological Filter,
and will help prevent the pond icing
over. However, the unit must not be
allowed to freeze. If you switch the
unit off for winter, wash the unit
thoroughly before resuming filtration
in the spring (see ‘Winter Storage’).
Never feed your fish when the unit is
not in use.
• ALWAYS UNPLUG OR DISCONNECT
ALL APPLIANCES IN THE POND FROM
THE ELECTRICITY SUPPLY BEFORE
PUTTING YOUR HANDS IN THE WATER
WHILST EQUIPMENT IS BEING
INSTALLED, REPAIRED, MAINTAINED OR
HANDLED.
• Do not use the supply cable to lift the
unit, as this may cause damage. We
recommend fitting a lifting cord to the
hook feature on the base, when the
filter is installed in deep water. (Fig 1-
H).
• Check that the voltage marked on
the unit corresponds to the mains
supply.
• A 10mA OR 30mA RESIDUAL
CURRENT DEVICE (RCD) MUST BE
FITTED TO THE MAINS SUPPLY.
• The pump is supplied with 10m of 3
core electric cable which is
permanently connected and sealed to
the pump.
The supply cable cannot be
replaced. If the cable is damaged, the
unit should be discarded.
This product
is designed to be permanently wired to
the mains supply in a dry weatherproof
enclosure through a Double-Pole
Switched Fused Spur - (Disconnector) to
BS 3676, with a minimum contact
separation of 3mm in each Pole &
Fitted with a 3 or 5 Amp fuse.
• The installation must conform to the
national and local wiring regulations
which could include the use of plastic
or metal conduit to protect the cable.
• THIS APPLIANCE MUST BE EARTHED
AND IT IS ESSENTIAL THAT THE
CONNECTIONS ARE MADE USING THE
FOLLOWING CODE;
The BROWN lead should be connected
to the LIVE terminal which may be
marked with an 'L' or coloured brown
or red. The BLUE lead should be
connected to the NEUTRAL terminal
which may be marked with an 'N' or
Brown - Live
Blue - Neutral
Green/Yellow - Earth
Periods of Operation
Electrical Safety