ASSEMBLY
1. Open the clips at either end of the
strainer cage and open the cage.
2. Remove the Wildlife Protection
system (Fig1 – a).
3. Remove & unpack the ball joint,
hosetails & outlet adaptor (Fig 1 – b, c
& d).
4.Remove the mains supply cable and
unwind.
5. Screw the outlet adaptor onto the
outlet of the pump. Do not over
tighten (Fig 4).
6. Locate the pump onto its mounting
area ensuring that the outlet adaptor
rests in the recess in the lower part of
the cage (Fig 5).
Note:1000 model: The pump locates
into a cradle that is fixed to the lower
cage (Fig 1 - g).
7. Locate the mains supply cable into
the recess on the side of the cage.
Ensure it is seated in the correct
position so that the cable does not get
trapped when the cage is closed. (Fig
6).
8. Close the cage lid and secure by
pressing in the centre of the clips (Fig
7).
TYPICAL INSTALLATION
PUMP ASSEMBLY & INSTALLATION
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 3
