HOZAN C-702-13, Инструкция по эксплуатации

Страница: 9 / 12

3
3
4
Operation
Inset the die head into the shaft after the set screw is
loosened enough.
Turn the die head set screw clockwise with the 2.5 mm
hex wrench aligning the set screw and the cavity on
the shaft to secure the die head.
Cut the spoke to the desired length.
If cutting edge appears as indicated by NG, reform
the tip of spoke with a file as indicated by OK.
There is no problem to cut on the middle of existing
threads.
Set the spoke in this tool.
Open the clamp by turning the clamp lever
counterclockwise a few revolutions.
Insert the spoke into the spoke insertion hole.
Turn the clamp lever clockwise to fix the spoke.
NG OK
・
Locate the spoke at the center of
three jaws.
・ The tip of the spoke must reach to the position
explained by the dotted line in the photo.
Set screw
Cavity Die head
Spoke insertion hole
Tightened Tightened
Insert Insert
Tightened
Loosened
Insert
Do not rotate the clamp.
Missed the center
Centered
NG
OK