HOZAN C-440, Операция

Страница: 6 / 8

２
２ ２
２
１． Maintain proper posture when using this tool.
２．
Wear gloves when using this tool.
３．
Do not remodel the C - 440.
４．
Do not use when cracks, breaks, wear or deformation is found on this tool.
５．
Lubricate the moving parts periodically.
６． Ball races with particular shape are not applicable.

Caution
This tool is designed for only removing ball race which is one of bicycle head parts. Do not use for any other purpose.
Precautions
Warning and caution symbols
These symbols are used throughout the instruction manual to alert the user to potential safety hazards as follows :

Warning
…
Notice when incorrect handling could cause the user's death or serious injury.

Caution
…
Notice when incorrect handling could cause injury to the user or material damage.
Even if the instructions do not have

Caution mark, there are some possibilities for a serious
situation. Follow the instructions.
● We ship the C-440 kept in good condition through the careful manufacture, however, the chuck installing
could have been loose due to vibration during transport. If so, the chuck will be turned with the chuck
cover together when the chuck cover is turned, causing a failure in catching the ball race. Take the handle
mount and the chuck cover off, and tighten the chuck clockwise securely.
Preparation
●
Regarding the size of ball race
The size of ball race is generally identified with inner diameter in inch. Not like other conventional
remover, the C-440 holds a ball race from over, therefore in this instruction manual the applicable size of
ball races are indicated by outer diameter in metric.
Finally determine the appropriate collar according to the size of outer diameter.

Caution … Do not install the collar upside down.
This could cause a damage of the chuck.

Caution
…
Using incorrect collar could cause damage of the ball race, the fork and the tool.
Be sure the size of collar.
Exchange the collar in following procedures.
Turn the handle mount and the chuck cover counterclockwise to take those
off, then remove the collar.
Place the other collar back. Inner flare of the collar should face downward
along the flare of the chuck. Place the chuck cover and the handle mount.
●
How to select the collar
・
・ ・
・
How to exchange the collar
１ １ １ １
２ ２ ２ ２
The C - 440 has two different size of collars in contents.
One is black collar for 36.0 to 40.0mm, the other is white collar for 40.5 to 47.0mm.
The black collar is installed when shipping out. Select the appropriate collar for the ball race.