To Synchronize Display Height and Actual Desk Height
Press and hold DOWN arrow to move desk
to its lowest height. Using a tape measure
or ruler, measure the actual desk height.
If necessary, press UP or DOWN arrow to
move desk to a full inch mark (31.0”, for
example). Record measurement.
Press UP or DOWN arrow to
increase/decrease second digit
to match the actual desk height
measurement (“1” in the example).
First, press and hold “S”. DO NOT
RELEASE. Next, press and HOLD
UP arrow. The first digit will begin
flashing on the display. NOW
RELEASE BOTH BUTTONS.
Press “S”. Second digit is now saved.
Third digit will begin flashing on
the display.
Press UP or DOWN arrow to
increase/decrease the first digit
to match the actual desk height
measurement (“31.0” in the
example in STEP 1).
Press UP or DOWN arrow to
increase/decrease third digit to
match the actual desk height
measurement (“0” in the example).
Press “S”. First digit is now saved.
Second digit will begin flashing on
the display.
Press “S”. Third digit is now saved.
Display height and actual desk
height are now synchronized.
OR
+
S
+
S
S
OR
OR
OR
S
S
Step 1
Step 5
Step 2
Step 6
Step 3
Step 7
Step 4
Step 8
Error Codes
Leg Malfunction
– Legs detached
from the Control Box. Check and
ensure the cable connection.
Button Stuck
– Check button. If
stuck, toggle to restore function.
Overheating
– Allow Control Box
to cool for at least ten minutes.
Communication Disconnected
–
Ensure connection between the Memory
Height Keypad and Control Box.
Table Top Overload (Load Too
Heavy)
– Remove excess weight
from desktop.
Display Measurement Not Calibrated to Actual Height
–
Screen displays below “0” when desk is at its lowest. Synchronize the display
height to the actual height. See Synchronize Display Height section.
Control Box Malfunction
–
Reinitialize the Control Box.
E01
E05
E02
E06
E03
E07
E04
E01
E05
E02
E06
E03
E07
E04
Advanced Operating Instructions and Troubleshooting
(Continued)
#497247-0121
7
Press and release “1” within three seconds of
releasing “S”. “H-0” on the display indicates One-
Touch is off; “H-1” indicates One-Touch is on.
Press UP arrow to change
“H-0” to “H-1”. Press DOWN
arrow to change “H-1” to “H-0”.
S
S
1
1
Step 2
Step 3
Resetting One-Touch Feature
Press and hold “S” for eight seconds.
“–––” will flash on the display.
Press and hold “S” for two seconds.
The display will return to the current
desktop height.
Step 1
Step 4
