Connect the Cable Extension and the Leg Cable.
Plug the loose end of the Cable Extension into the
Control Box.
Locate a Foot and four M6 x 35mm
bolts. Align the holes on the Foot with the
holes on the bottom of the Leg. Make sure
the Foot is installed so the longer section
of the Foot Leg faces the front of the
Desktop. Use the hex key provided
to tighten the four bolts.
(Repeat steps 2-5 for the second leg.)
Use the two screws provided to fasten
the Memory Height Keypad to the
underside of the desktop using the
predrilled holes in the right-front
edge or left-front edge of the Desktop.
(See locations A1 and A2 on
page 3.)
Plug the Memory Height Keypad Cable
into the Control Box. Plug the Power
Cable into the Control Box. Use the Wire
Management Ties provided to secure
cables to the underside of the Desktop
as desired.
If other Accessories need to be assembled, refer to pages 3 and 4 to
reference the Desktop Accessory Diagram for locations and instructions.
With two people, turn the fully assembled desk onto its feet. Finally, refer to
page 5 and follow the instructions to set up the Memory Height Keypad.
Front of Desktop
Foot
Longer section
of Foot
Front of Desktop
Levelers (4)
Control Box
Control Box
Control Box
Memory Height
Keypad
Front of
Desktop
Memory Height
Keypad Cable
Power Cable
2
Your desk may appear different
than the diagram shown.
