23800-5-0909
Page 14
ATTACH HERE IF BLOWER
IS INSTALLED
Figure 24
3. Align clearance holes on outer casing bottom with screw holes
on casing brackets by adjusting slots on casing brackets.
4. Complete tightening casing bracket screws from Step 1 to
inner casing at this time.
5. Attach outer casing to casing brackets with two (2) 10 x 1-1/2"
screws.
CASING BRACKET
SCREW HOLES
Figure 25
INSTALLING CONTROL DOOR
Attach two washers supplied in hardware package to pivot pins
located at bottom of control door. Install control door to outer
casing assembly.
NYLON WASHER
CASING DOOR
Figure 26
FINISHING INSTRUCTIONS
2. Place outer casing onto header.
CASING FRONT
ASSEMBLY
Figure 22
Attention:
Use center clearance hole on outer casing top for
attachment to header with one (1) 8 x 3/8" Phillips screw
when
optional blower is not installed.
ATTACH HERE IF NO
BLOWER IS INSTALLED
Figure 23
Attention:
Use outside clearance holes on outer casing top for
attachment to header with two (2) 8 x 3/8" Phillips screws
when
optional blower is installed.
