7
1. Disconnect power source.
2. Lay drill on its side with feed wheel up to be sure
arbor clears table if unit is in normal operating position.
3. Turn feed handles until cutter mounting set screws are
exposed and then completely remove the set screws.
4. Insert proper pilot into shank end of the cutter.
5. Insert the Cutter until flats on cutter shank are
aligned with set screw holes and is exactly perpendicular
to the axis of set screw hole.
6. Insert Set Screws and tighten.
NOTE: Arbor, Hougen part number #03736 and #40242
applies only to Models 10909 and 10914.
Arbor, Hougen part number #03737 applies ONLY to “S”
Models.
Pilot
40222 Set
Screws go here
"12000-Series"
Hougen Cutter
INSTALLING HOUGEN
CUTTER IN ARBOR
04375
Front Support Bracket
40299 Spacer
04375
Front Support Bracket
40299 Spacer
1" & 2" Depth of Cut
3" Depth of Cut
NOTE : Spacers must always be installed with short side toward arbor
40451 Bolt
40391 Lock Washer
40392 Flat Washer
Adjusting Arbor Support Bracket for Depth
