11
Operations
Operations Instructions
To Clean
WARNING: Risk of injection or severe injury - Keep
clear of nozzle - DO NOT direct discharge stream at
persons - This machine is to be used only by
qualified operators.
AVERTISSEMENT: RISQUE D’INJECTION ET DE
BLESSURES GRAVES. SE TENIR À L’ÉCART DU
JET. NE PAS DIRIGER LE JET DE SORTIE VERS
D’AUTRES PERSONNES. CONFIER L’UTILISATION
DE CE MATÉRIEL À UN OPÉRATEUR QUALIFIÉ.
1.
Insert detergent inlet line into container of mixed
detergent. Open detergent ON/OFF valve. The
detergent will be pulled automatically into the
system. Allow detergent to reach end of wand
before proceeding to step 3.
2.
Select pressure nozzle with spray pattern that
matches your cleaning needs. Engage manual
trigger lock and install selected nozzle.
3.
Wash from the bottom to the top, using side to side
motions. This washes away heavy dirt and allows
the detergent to soak as you work toward the top.
4.
Do not wash at a 90°
angle to the work (straight at
it). This will allow water to splash back at you and
reduces your cleaning power. Wash at a 30° to 60°
angle to the work. This will allow the water to
splash away from you and the water will wash the
dirt away faster and easier.
5.
Use the width of the spray pattern to wash in a
wide path. Overlap spray paths for complete
coverage. Wash from side to side, using slow,
steady motions.
6.
The nozzle should be 12" to 24" from work, closer
for tough areas. Be careful on painted or delicate
surfaces, the pressure may damage surface if
nozzle is too close.
7.
Small parts should be washed in a basket and
larger, lightweight parts should be clamped down
so the pressure does not push them away.
8.
Close the detergent ON/OFF valve to permit rinse.
Always rinse with cold water after using detergents.
Rinse from the top to the bottom to prevent
detergent from dripping onto a rinsed area. For the
best results, contact your Hotsy dealer to help you
select the best detergent for your application.
HOTSY • CWC OPERATOR’S MANUAL • 9.801-695.0-B
