ii
installation
&
operation
manual
|
oxm
/
ogm
heating
system
IMPORTANT SAFETY INFORMATION
WARNING
!
Hazardous voltage:
Before wiring, servicing or cleaning the heating system, turn off the power and follow your
organization’s lockout and tagout procedure. Failure to do so could allow others to turn on the power unexpectedly,
resulting in harmful or fatal electrical shock.
Electrical hazard:
All electrical work must be done by qualified personnel in accordance with national, state and local
codes.
CAUTION
!
Read instructions carefully:
The safety of any system incorporating this heater is the responsibility of the assembler.
The safe and proper use of this heater is dependent upon the installer following sound engineering practices. If the
equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may
be impaired. All applicable electrical safety standards defined by local jurisdictions must be followed. (Reference EU
directive 2006/95/EC in EU countries.)
•
Read carefully:
Installers and operators of this equipment must be thoroughly familiar with the instructions in
this manual before commencing work.
•
Hot surfaces:
Avoid contact with the system while it is in service. Some surfaces may remain hot even if the
system is not energized.
•
Proper lifting:
Proper rigging and safety equipment must be used to move this equipment. Do not lift the
heating system by any cords, electrical conduit or cabling. Create a plan before attempting to move. Proper
lifting locations are identified on each system; use these locations when lifting and mounting the system.
•
Rotating equipment:
The heating system can start automatically and without warning. Avoid contact unless a
lockout at the service panel has been installed.
•
Grounding:
The heater must be connected to a suitable ground (protective earthing conductor).
•
Overcurrent limiting:
The power supply must be protected by a suitable overcurrent
limiting device.
•
Power disconnection:
A means to disconnect the heater from the power supply is required. HOTSTART
recommends that a power switch or circuit breaker be located near the heater for safety and ease of use.
NOTICE
EU Countries only:
Equipment rated for the conditions listed in EN 601010-1 1.4.1 Ingress protection rating IP55.
(Special conditions for specific applications may apply.)
