Page 1
Page 1
Safety Information
SAFETY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
AVOIDING THE RISK TO CHILDREN
DANGER:
•
RISK OF CHILD DROWNING.
Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents,
ensure that children cannot use a hot tub unless they are supervised at all times.
WARNING:
• To reduce the risk of injury, do not permit children to use this hot tub unless they are closely supervised at all times.
• To reduce the risk of injury, lower water temperatures are recommended for young children. Children are especially sensitive to hot water.
DO:
• Make sure you always lock the child resistant locks after using the hot tub for your children’s safety. Every Limelight
TM
hot tub is equipped
with a locking cover that meets the ASTM F1346-91 Standard for Safety Covers.
• Test the water temperature with your hand before allowing your children to enter the hot tub to be sure that it’s comfortable. Children are
especially sensitive to hot water.
• Remind children that wet surfaces can be very slippery. Make sure that children are careful when entering or exiting the hot tub.
DON’T:
• Allow children to climb onto the hot tub cover.
• Allow children to have unsupervised access to the hot tub.
AVOIDING THE RISK OF ELECTROCUTION
Risk of electrocution
• Connect only to a grounded source.
• Do not bury the power cord. A buried power cord may result in death, or serious personal injury due to electrocution if direct burial-type
cable is not used, or if improper digging occurs.
• A ground terminal (pressure wire connector) is provided on the control box inside the unit to permit connection of a minimum No. 10 AWG
(6 mm
2
) solid copper bonding conductor between this point and any metal equipment, metal water pipe, metal enclosures of electrical
equipment, or conduit within five feet (1.5 m) of the unit as needed to comply with local requirements.
• Do not operate the audio main controls while inside the spa (if spa is equipped with an audio component).
• Do not connect any auxiliary components (for example, cable additional speakers, headphones, additional audio components) to the
audio system unless approved by Watkins Manufacturing Corporation .
• Do not self service audio component by opening or removing cover as this may expose dangerous voltage or other risk of injury. Refer all
servicing to qualified service personnel.
• Do not attach an external antennae to a spa audio system unless installed by a licensed electrician in accordance with Article 810 of the
National Electric Code, ANSI/NFPA 70.
WARNING:
• To reduce the risk of electrical shock, replace a damaged cord immediately. Failure to do so may result in death or serious personal injury
due to electrocution.
230 volt, permanently installed
• A ground terminal is provided on the terminal block (TB-1, system ground terminal) located inside the control box. To reduce the risk of
electric shock, connect this terminal to the grounding terminal of your electrical service or supply panel with a continuous green, insulated
copper wire. The wire must be equivalent in size to the circuit conductors supplying the equipment. In addition, a bonding terminal
(pressure wire connector) is provided on the outside of the control box for bonding to local ground points. To reduce the risk of electric
shock, this connector should be bonded with a No. 10 AWG (6 mm
2
) solid copper wire to any metal ladders, water pipes, or other metal
within 5 feet (1.5 m) of the hot tub to comply with local requirements. The means of disconnection must be readily accessible, but must be
installed at least 5 feet (1.5 m) from the hot tub.
• Your hot tub is provided with a suitably rated circuit breaker to open all ungrounded supply conductors.
Содержание FLR
Страница 1: ...Page 1 O w n e r s M a n u a l by...
Страница 43: ...Page 40 Page 40 NOTES...
