Hotronix 360 IQ HAT PRESS, Руководство оператора, Страница: 7 / 16

7
Before heat applying, set the target settings for the selected transfer material by:
• Selecting a Preset (7.1), or
• Manually entering target temperature, time, and pressure.
Temperature and time are controlled automatically. Pressure must be set manually:
• Position a cap on the lower heater (4.1).
• Lower the cap hold-down lever (4.2) to lock in place.
• Enable Target Temp option in System settings (11.1) to prevent the electromagnet
from locking down until temperature is reached.
• Pull lift handle down and observe the pressure reading.
• Adjust the pressure by turning the Pressure Adjustment Knob.
A visual pressure readout is located on the Home Screen. When the handle is locked
in the PRINT position, a pressure number between 0-9 is displayed.
• 0 = No Pressure.
• 1 - 3 = Light Pressure.
• 4 - 7 = Medium Pressure.
• 8 - 9 = Heavy Pressure.
WARNING : Structural damage caused by excessive pressure is not covered under the limited warranty!
The lower heater alignment can be adjusted by loosening the knob to accomodate
different cap sizes (4.3).
When the desired temperature is reached:
• Position the cap and design (4.1).
• Lower the cap hold-down lever to lock cap into place (4.2).
• Pull lift handle down and begin to heat apply.
• The automatic timing process will begin.
• The Home Screen will initiate a count down and lift the heat platen into the UP
position when print cycle is complete (4.4).
Prepare to Print
4.2
4.1
4.3
4.4
Tips for Successful Printing:
• Hold hat by the sides of bill and load from side of platen.
• Align seam of bill with lip on lower platen for access to full print area.
• Extend sweatband out when possible to ensure smoother application.
• Cover logo with included pad matching thickness of material.
• Always best to remove hat from press before peeling backing to let
adhesive cool and set.
• Don’t pick or pull at emblem or patch for 24 hours to ensure adhesion.