Hotronic TECH DRY, Руководство по эксплуатации, Страница: 20 / 126

TECH DRY
20
5. Maintenance
5.1 Cleaning

Make sure that you unplug the device before cleaning!

The outside of the device can easily be cleaned with a clean cloth.

Never empty or spray cleaning agents into the device.

Cleaning of the technical components, if this is really required, must be performed by qualified
personnel.
6. Service and troubleshooting
6.1 The dryer does not operate

Check if the plug is plugged in and switched on.
(UK 3-pin plugs are fitted with a fuse.)

If it still does not operate and
1. E1 displays on screen: Temperature controller does not work.
2. E2 displays on screen: Heater does not work.
6.2 The dryer does not dry perfectly:
Check if the drying temperature is set too low. Reset to a higher value.
If the object you are drying is too wet, squeeze out excess water.
6.3 Water under base:
The dryer can drain small amount of water, but very wet object should not be placed on holders, it will
burn your device and permanently damage it.
ATTENTION:
INSTRUCTIONS THAT APPEAR IN THIS USER GUIDE ARE NOT MEANT TO COVER EVERY
POSSIBLE CONDITION OR SITUATION THAT MAY OCCUR. GOOD JUDGMENT MUST BE USED
WHEN OPERATING THIS OR ANY OTHER DEVICE.