GB
Installation
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to a
cold water tab using a
3/4 gas threaded
connection
(see figure).
Before performing the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the other end
of the water inlet hose to
the washing machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see
figure)
.
3. Make sure there are no kinks or bends in the hose.
!
The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page)
.
!
If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.
!
Ensure that the supply taps are allowing water
through. Old taps may seize in the closed position
and thus prevent water reaching the machine.
!
Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.
!
Read these instructions carefully: they contain
vital information on installation, use and safety.
Unpacking and levelling
Unpacking
!
This a part of the
polystirene base and
should have stayed
intact when you
removed the base.
!
IMPORTANT check
when unpacking your
machine.
1. Unpack the washing machine.
2. Check whether the washing machine has been
damaged during transport. If this is the case, do
not install it and contact your retailer.
3. Remove the
4
protective screws and
the rubber bush with the
respective spacer,
situated on the rear of
the appliance
(see also
the installation leaflet)
.
4. Do not remove external bar.
5. Seal the gaps using the plastic plugs provided.
6. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
!
Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of noise
if the two front feet have not been adjusted correctly.
1. Install the washing
machine on a flat sturdy
floor, without resting it
up against walls, furniture
cabinets or other.
2. If the floor is not perfectly level, compensate for
any unevenness by tightening or loosening the
adjustable front feet
(see figure)
; the angle of
inclination, measured according to the worktop,
must not exceed 2°.
All manuals and user guides at all-guides.com
