7
Impor
tant
Inf
ormation
Installation
Description
Star
t and
Pr
ogrammes
Laundr
y
W
arnings and
Sug
g
estions
Maintenance
and Care
Ser
vice
T
roub
leshooting
GB
Programmes Table (TVM562 only)
Programme
What it does...
How to set it...
Note:
Automatic
Drying
(average loads)
Dries completely:
your clothes are ready to be
worn.
For average loads (from 1 to
3kg) of Cotton, polycotton or
synthetics.
!
If you select LOW HEAT,
this programme will not dry
your clothes. For Acrylic
fibres or small loads select
Timed Drying.
This programme can also be
used for large loads if you
require a slightly drier result.
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on
.
3. Press the START button , the
ACTIVE light will turn on.
Automatic
Drying
(large loads)
Dries completely:
your clothes are ready to be
worn.
For large loads (from 3 to 6kg) of
Cotton.
!
If you select LOW HEAT,
this programme will not dry
your clothes. For Acrylic
fibres or small loads select
Timed Drying.
This programme can also be
used for average loads if you
prefer a damper result.
Timed Drying
(up to 120 minutes)
Dries wet clothes that will be
ironed, Acrylic fibres, or small
loads (less than 1kg).
If you prefer a timed programme
can be used for other fabrics on
HIGH or LOW heat as appropriate
(
see Laundry
).
Consult suggested drying
times (
see Laundry
).
!
This is not a drying
programme (
see below
).
1. Position the PROGRAMMES knob
on .
2. Press the START button , the
ACTIVE light will turn on.
Use to refresh fibres of clothing
(approximately 10 minutes).
1. Select required heat setting HIGH
HEAT or LOW HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on the desired time.
3. Press the START button , the
ACTIVE light will turn on.
Easy Iron
Cool Tumble
Brief programme (approximately
10 minutes) that softens fibres of
clothing that is ready for ironing.
!
This is not a drying
programme (
see below
).
Easy Iron Programme
‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle
relaxes the fibres and makes them easier to iron and fold.
!
‘Easy Iron’ is
not a drying programme
and should not be used for wet articles of clothing.
For best results:
1.
Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric
Maximum load
Cotton and Cotton mixtures
2.5kg
Synthetics
2kg
Denim
2kg
2.
Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put
them away in the closet. Should this not be possible repeat the programme.
The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix,
and less well on acrylic fibres and on materials such as Tencel®.
Start and Programmes
1. Select HIGH HEAT
by pressing the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button , the
ACTIVE light will turn on.
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button , the
ACTIVE light will turn on.
Cool Tumble Phase
This is the programmes’ final phase. Approximately 10 minutes before the finish, the knob advances automatically to
the Cool Tumble Phase. Heating elements turn themselves off and clothing is cooled down, after this the Buzzer will
sound (if selected) and the clothing is ready to be taken out.
!
Always allow the dryer to complete this phase.
