GB
15
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
F
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap
G 9.
3. Replace the glass cover (see
diagram).
!
Do not touch the light bulb directly with your hands.
!
Do not use the oven lamp as/for ambient lighting.
Sliding rack kit assembly
To assemble the sliding racks:
1. Remove the two frames, lifting
them away from the spacers A (see
figure).
Glass cover
Lamp
Lamp
Holder
compartment
A
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is
to be extracted, position joint B and
then joint C on the frame.
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram).
The holes for the left frame are
situated at the top, while the holes
for the right frame are at the bottom.
4. Finally, fit the frames on the
spacers A.
!
Do not place the sliding racks in position 5.
WHEN USING THE MAIN OVEN
YOU MUST ENSURE THAT THE
BASE OF THE CAVITY IS NOT
COVERED WITH ALUMINUM
FOIL, UTENSIL OR ANY OTHER
FORM OF COVERING. FAILURE
TO DO THIS MAY RESULT IN
THE CAVITY BEING DAMAGED.
! ATTENTION
Side and rear catalytic liners
These are panels coated with a special enamel, which is able to absorb the
fat released by food as it cooks.
This enamel is quite strong, so that the various accessories (racks, dripping
pans, etc.) can slide along them without damaging them. White marks may
appear on the surfaces; these are not a cause for concern.
Nevertheless, the following should be avoided:
- scraping the enamel with sharp objects (a knife, for example);
- using detergents or abrasive materials.
B
C
Left
guide rail
Right guide
rail
Direction
of extraction
D
