![Hotpoint RB734J Скачать руководство пользователя страница 26](http://html1.mh-extra.com/html/hotpoint/rb734j/rb734j_use-and-care-manual_2167676026.webp)
Care and
To
Upper Oven tick
*M-~* Oven
(Model
can be
cleaned in the self-clean oven.)
Place shelf from upper oven on
either shelf of self-clean oven. (Shelf
may have to be shifted slightly so
shelf stops do not interfere with
placement of panels.)
Slide out oven bottom;
bake
unit slightly makes this easier to do.
Lift back panel and remove. Place
bottom
back panels back-to-back
so soiled sides face outward. Place
these panels over shelf on
STRAIGHT shelf. It is important
that panels lay flat on shelf.
Lift side panels up and out of oven.
Place back-to-back on remaining
self-clean shelf.
To Replace
in
Upper Oven
Replace panels in any order
desired. Be certain oven bottom
is replaced so notch is at right,
and “feet” on bake unit rest in
depressions in panel. Replace
broiler reflector so “open side”
is toward bottom of oven.
Oven Thermostat
Use time given on recipe when
cooking for first time. Oven
thermostats may “drift” from the
factory setting over the years, and
5 to 10-minute differences in timing
between an old and a new oven are
not unusual. Your oven has been set
correctly at the factory and is more
apt to be accurate than the oven
which it replaced. However, if you
find that your foods consistently
brown too little or too much, you
may make a simple adjustment in
the OVEN
thermostat knob.
PULL KNOB OFF SHAFT. LOOK
AT BACK OF KNOB AND
CURRENT SETTING BEFORE
MAKING ANY ADJUSTMENT.
To increase temperature, turn
toward RAISE; to decrease, turn
toward LOWER. Each notch
changes temperature
Follow appropriate instructions
below or at right to adjust your
oven thermostat.
1. Remove knob, and hold so pointer
is at top of knob. Using a pot holder
or similar material, hold “skirt” of
knob firmly in one hand. Grasp
handle of knob in other hand. Note
position of pointer and turn handle
to move pointer toward Raise or
Lower. Pointer is designed not to
move easily. If it is seated so it is
difficult to move, pointer maybe
loosened slightly. Insert a thin
screwdriver, knife blade or similar
instrument and lift up end of
pointer slightly.
2. After adjustment is made, press
monitor
against knob. Return
knob to range, matching flat area
on knob and shaft.
Recheck oven performance before
making an additional adjustment.
1. Pull off knob. Loosen both
screws on back of knob.
2. Move pointer one notch in
desired direction. Tighten screws.
3. Return knob to oven, matching
flat area of knob to shaft. Recheck
oven performance before making
an additional adjustment.
26