Switch off the electricity supply and allow to cool before cleaning the
cooker.
Clean the cooker regularly and wipe up spills soon after they occur to
prevent them from becoming burnt on. Never use biological washing
powder, caustic cleaners, harsh abrasives, scouring pads, aerosol cleaners
or oven chemical cleaners of any kind.
Before moving your cooker ensure that it is cool and note that it is heavy
(approximately 70 kg 155 lbs), so you may require assistance. To move the
cooker forward, open the top oven/grill door and with both hands positioned
under the roof of the compartment, lift and pull forward. Replace by pushing the
cooker backwards. Check that the cooker is level. Take care to ensure that any
floor covering is not damaged.
MAIN OVEN HEAT CLEAN LININGS
The oven back and side linings are coated with a special enamel
which has a continuous cleaning action. The higher the oven temperature
the more effective the action. In most cases this cleaning operation will
proceed during normal cooking. However, if roasting is done frequently, or
high temperatures are not used regularly, it may be necessary to run the
oven empty at Mark 8 for about two hours.
It should not normally be necessary to clean the linings with water, but if
desired, wipe them over with a soapy cloth, followed by a wipe with a
damp clean cloth.
REPLACEMENT OF OVEN LIGHT BULB
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY
SUPPLY BEFORE REPLACING THE LAMP
Light bulbs are not covered by the manufacturer’s guarantee.
A new 25W, 300
o
C rated SES bulb can be obtained from your cooker supplied or
any major electrical retailer.
1. Remove the shelves from the oven.
2.
Unscrew the lens using a thick cloth to protect your fingers in the
unlikely event of a lens fracture.
3.
Unscrew bulb.
4.
Fit new bulb and refit lens.
23
CARE AND CLEANING
