Hotpoint Aquarius FDW60, Инструкция по установке и эксплуатации

Страница: 18 / 28

18
D
ISHWASHER
Fault Area
Issue Cause/How to resolve…
Wash Cycle indicator
light 4 flashing (Fast).
- Water load solenoid valve
malfunction alarm.
If indicator light 4 (Fast) flashes rapidly, TURN the dishwasher OFF AND
BACK ON again after one minute. If the alarm persists, first turn off the
water tap to avoid any flooding and then cut off the electricity supply and
call for technical assistance.
Indicator 4
(Fast)
Cycle Phase Indicator
Lights Flashing
“Drying” light flash-
- Indicates and of programme
The “Drying” phase indicator light will flash in the display to indicate the
programme is complete.
- Press the “On/Off” button to switch off the dishwasher.
Please Note:
When your dishwasher is switched back on, the “Drying”
phase indicator light will continue to flash ntil a new
programme is selected or the machine is reset - This is
normal.
When a “Pre-Wash” programme
is selected, the “Rinse” light will
illuminate.
This is normal - The Rinse Light, rather than the Prewash light illuminates
because Prewash is basically a “Cold Rinse” cycle. (i.e. the machine is
using part of the rinse cycle to give the Prewash function).
Poor Wash Results
Residue On Dishes When Wash
Cycle Complete.
- Is the selected programme suitable for the type of load and the
degree of soiling?
- Check the loading of your crockery into the baskets (See “Loading
You Dishwasher” Section of the instruction book).
- Check that the filters are clean and in place (See “Care and
Cleaning” Section of the instruction book.)
- Is the lid of the salt container closed properly?
- Is the rinse aid dosage correct?
(See section “Poor Drying Results” below for instructions on adding
or adjusting rinse aid to your wash).