Hotpoint Ariston MBZE 45 NF BAR, Инструкция по эксплуатации

Страница: 16 / 72

16
GB
! Before operating your new appliance please read these
instructions carefully. They contain important information
for safe use, installation and care of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated, dry room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation in order
to operate correctly and save energy.
3. Leave a space of at least 10 cm between the top part
of the appliance and any furniture above it, and at least 5
cm between the sides and any furniture/side walls.
4. Ensure the appliance is kept well away from any
sources of heat (direct sunlight, electric stove, etc.).
Levelling
1. Install the appliance on a level and sturdy floor.
2. If the floor is not perfectly horizontal, adjust the
refrigerator by tightening or loosening the front feet.
Electrical connections
After transportation of the appliance, carefully place it in
an upright position and wait at least 3 hours before
connecting it to the electricity mains. Before inserting the
plug into the electrical socket ensure the following:
• The appliance is earthed and the plug is compliant
with the law.
• The socket can withstand the maximum power of the
appliance (this is indicated on the data plate in the
bottom left section of the refrigerator compartment),
for example 150 W).
• The voltage is in the range of values indicated on the
data plate located on the bottom left section (e.g. 220-
240V).
• The socket is compatible with the plug of the
appliance.
If the socket is incompatible with the plug, ask an
authorised technician to replace it ( see Assistance ). Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only ( see Assistance ).
! The manufacturer declines any liability should
these safety measures not be observed.
Bar compartment
The stiffness of the door
opening/closing movement for
the bar compartment may be
adjusted. When you are in front
of the appliance, turn the two
lateral rods to the left if you wish
to stiffen the movement, or to
the right if you wish to loosen the
movement.
! The two brackets must be adjusted to the same
stiffness level. Turn each rod the same number of times,
in the same direction.
Installation