GB
25
Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity supply before carrying out
any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external parts and the rubber seals
may be cleaned using a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the removal of stubborn
stains. After cleaning, rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned after each use, while it is
still lukewarm. Use hot water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding racks - can be washed
like everyday crockery, and are even dishwasher safe.
• We recommend that detergents are not sprayed directly onto the control
panel, but that a sponge is used instead.
!
Never use steam cleaners or pressure cleaners on the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and a non-abrasive
cleaning product, then dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these could scratch the surface
and cause the glass to crack. For more thorough cleaning purposes, the oven
door may be removed:
1. Open the oven door fully (see diagram);
2. Lift up and turn the small levers located on
the two hinges (see diagram);
3. Grip the door on the two external sides
and close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: Wattage 25 W,
cap E 14.
3. Replace the glass cover (see
diagram).
!
Do not use the oven lamp as/for ambient lighting.
Sliding rack kit assembly*
To assemble the sliding racks:
1. Remove the two frames, lifting them
away from the spacers
A
(see figure).
2.Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is to
be extracted, position joint
B
and then
joint
C
on the frame.
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram). The
holes for the left frame are situated at
the top, while the holes for the right
frame are at the bottom.
4. Finally, fit the frames on the spacers
A
.
!
Do not place the sliding racks in position 5.
A
B
C
Left
guide rail
Right guide
rail
Direction
of extraction
D
*
Only available on certain models.
