33 of 36
Indesit
Company
Service Manual UK
English
O.
Motor
1.
Remove drum assembly (Q)
2.
Remove back panel (S)
3.
Remove front panel and air duct
assembly complete. (I)
4.
Remove 4 screws securing motor to
heat exchanger surround.
5.
Release Capacitor securing screws
and remove capacitors. (V)
6.
Unplug thermistor wiring, and remove
pump wiring from heat exchange
cover.
7.
Remove 10 screws securing the heat
exchange cover and remove cover.
Please note:-
On reassembly ensure
correct orientation of motor (note the wire exit point) and do not replace fixing screws until belt
has been refitted as per belt refitting section.
Ensure that heat exchange cover is located properly before replacing its securing screws.
Q.
Drum Assembly
1.
Remove top cover as in (A)
2.
Remove side panel's as in (B)
3.
Remove water container support as in (F). Ensure door is closed before moving to next stage.
4.
Remove rear bearing as in (M)
5.
Release belt from motor pulley.
6.
Disconnect mains terminal and earth lead from back panel.
7.
Remove 2 screws securing side strut to rear panel.
8.
Ease rear panel away from drum shaft and withdraw drum from left hand side of cabinet.
9.
Reassembly is reverse procedure it will be necessary to remove motor fixings to refit belt refer
to belt removal.
R.
Pipe Thermistor
1. Remove the Drum Assembly. (Q)
2. Disconnect the electrical plug to the thermistor.
3. Remove the thermistor from its housing, noting location and fitting.
S.) Rear
Panel
1.
Remove top panel as in (A)
2.
Remove Air Flow fan (W)
3.
Remove pump (N)
4.
Remove both side panels. (B)
5.
Remove rear bearing. (M)
6.
Remove container support (F)
Wire exit point
