Hotpoint Ariston 70FH G IX RU/HA, Руководство по эксплуатации

Страница: 4 / 24

4
GB
Before connecting to the power supply, make sure
that:
• the appliance is earthed and the plug is compliant
with the law.
• the socket can withstand the maximum power of
the appliance, which is indicated on the data
plate ( see below ).
• the voltage is in the range between the values
indicated on the data plate ( see below ).
• the socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced
by authorised technicians only ( see Assistance ).
Th e man uf a ctu rer de cl ines an y l iabi l i ty s houl d th ese
sa f e ty meas u res n ot be o bserved.
G as c onne c tion
The appliance should be connected to the main gas
supply or to a gas cylinder in compliance with
current National regulations. Before carrying out the
connection, make sure the cooker is compatible with
the gas supply you wish to use. If this is not the
case, follow the instructions indicated in the
paragraph “Adapting to different types of gas.”
When using liquid gas from a cylinder, install a
pressure regulator that complies with current
National regulations.
Check that the pressure of the gas supply is
consistent with the values indicated in Table 1
(“Burner and nozzle specifications”) since this will
ensure the safe operation and longevity of your
appliance while maintaining efficient energy
consumption.
Should you need to install a gas hob on top of a
built-in gas oven, it is strictly forbidden to connect
the two or to use a single cut-off tap. The two
appliances should be connected separately, and
each one should have its own stop tap in order to
make them completely independent from one
another ( see figures ).
Connection w ith a rigid pipe ( copper or steel )
Connection to the gas system must be carried out
in such a way as not to place any strain of any kind
on the appliance.
There is an adjustable L-shaped pipe fitting on the
appliance supply ramp and this is fitted with a seal in
order to prevent leaks. The seal must always be
replaced after rotating the pipe fitting (the seal is
provided with the appliance). The gas supply pipe
fitting is a threaded 1/2 gas cylindrical male
attachment.
Connecting a fle x i b le j ointless stainless steel
pipe to a threaded attachment
The gas supply pipe fitting is a threaded 1/2 gas
cylindrical male attachment.
These pipes must be installed so that they are never
longer than 2000 mm when fully extended. Once
connection has been carried out, make sure that the
flexible metal pipe does not touch any moving parts
and is not compressed.
Only use pipes and seals that comply with current
National regulations.
Checking the tightness of the connection
When installation has been completed, check the
pipe fittings for leaks using a soapy solution. Never
use a flame.
Adapting to different t y pes of gas
In order to adapt the oven to a type of gas other
than the type for which it was manufactured
(indicated on the label), follow these simple steps:
• Replacing the oven burner nozzle
1. Open the oven door fully.
2. Slide out the bottom of the
oven.
NO
OK