5
HW40RMA
This model is designed for free-standing installation only. The top of the cabinet must not be covered and it will get
warm during normal operation. It is recommended that a minimum clearance of 100mm is left at the sides and rear of
the appliance to allow air to circulate. Appliance dimensions are 845 x 495 x 585mm (H x W x D).
HW46MA
This model is designed for built-in or free-standing installation. The warm air is expelled through the vents in the front
plinth. This area must be kept clear when the appliance is installed.
Appliance dimensions are 870 x 595 x 575mm (H x W x D). The feet are adjustable so the cabinet height can be
increased up to 890mm. The minimum cabinet opening dimensions required are 878 x 610 x 625mm.
Reversing the Door
Note:
The door on the HW40RMA model is not reversible.
HW07MA, HW19MA, HW46MA
These models are supplied with the door opening from the left hand side. To reverse the opening direction, please
follow the instructions given below:
•
Remove the 2 screws underneath the right lower hinge.
•
Gentle pull the bottom of the door forward and remove the lower door pin.
•
Lower the door away from the right top hinge and carefully place aside.
•
Remove both the right upper hinge and the right lower hinge.
•
Remove the black plastic pegs from the cabinet on the left hand side and insert them into the holes on the right
hand side.
•
Secure the left top hinge and left bottom hinge (supplied) to the cabinet.
•
Locate the door onto the left top hinge and hold the lower door pin in place.
•
Align the door with the cabinet and secure the 2 screws through the left lower hinge into the lower door pin.
•
Check that the door opens freely and that the seal is made all round.
OPERATING YOUR WINE CABINET
HW07MA
•
LAMP Button
Used to turn the interior light on/off.
•
SET Button
Used to select the required temperature.
