Hostess HM250A, Инструкция по эксплуатации, Страница: 3 / 8

3
2. Frothing Hot Chocolate
Fig.7 Remove the lid.
Fig.8 Press the blender firmly onto the spigot in the bottom of the pot. Check that it rotates freely.
Fig.9 Pour the required amount of milk into the pot, up to the 250ml Max level.
(If more milk is poured into the pot you risk the beverage overflowing!)
Fig.10 Pour the chocolate into the pot.
Fig.11 Replace the lid.
Fig.12 Place the pot onto the base unit. Plug in the appliance and switch on the mains supply.
Fig.13 Select the button marked . The indicator light will come on and the blender will start to rotate the
milk. After approximately 1½ - 4 minutes the hot chocolate will have reached the pre-set temperature (~70°C)
and the appliance will automatically switch off. The luscious hot chocolate can now be poured into your cup. If
you want to stop the appliance at any time, press the button a second time.
Note: If the button marked is pressed again whilst the Milk Frother is still hot, then it will automatically run
for a further 4 minutes. (approximately).
CHANGING THE BLENDER/STIRRER
The Milk Frother is supplied with two blenders, marked ’foam’. These will produce a frothy drink. The stirrer
marked ’mix’ can be used to produce a hot drink that is not frothy.
To change the blender firmly pull the blender upwards, at an angle to the base, to remove it from the spigot in
the base of the pot. Position the required blender onto the spigot and then press firmly downwards until it
clicks into place. Ensure that the blender rotates freely on the spigot.
The spare blender and stirrer are located on the underside of the base unit.
Note - If you wet the bottom of the pot with a little tap water this will speed up
the heating operation.