7
C. Setup
1. Remove the Unit from the Pallet
1) Move as close to the final location as possible.
2) Remove the 2 bolts securing the unit to the pallet, then remove the unit from the pallet.
Block the unit securely at a height of 8" (20 cm) off the floor. Do not lay the unit down.
3) Attach the adjustable legs or casters to the bottom of the unit. Locking casters should be
attached to the front of the unit.
2. Optional Overflow Pan Installation (if applicable)
Optional overflow pan kits are available for the unlikely event that water cannot
evaporate from the condensate pan at a high enough rate.
a) Reach-In Optional Overflow Pan (HS-3521)
1) Attach the overflow pan brackets by
engaging the tabs on the brackets through
the holes in the bottom of the unit and
securing with the 4 mounting screws
provided. See Fig. 1.
2) Slide the plastic overflow pan into place
under the vinyl hose on the back of the
cabinet.
b) Pass-Thru Optional Overflow Pan (HS-3560)
1) Attach the overflow pan brackets by engaging the tabs on the brackets through the holes
in the bottom of the unit and securing with the 2 mounting screws provided. See Fig. 2.
2) Slide the plastic overflow pan into place under the vinyl hose on the side of the cabinet.
Fig. 1
Cabinet
Overflow Pan
Bracket
Mounting
Screws
Overflow
Pan
Tab
Mounting
Screws
Overflow Pan
Bracket
Reach-In Series
Fig. 2
Tab Holes
Left Bracket
Right Bracket
Overflow Pan
Tab Holes
Mounting Screw
Pass-Thru Series
Vinyl Hose
Mounting Screw
