7
ENGLISH
8. Startup
WARNING
1. This icemaker is designed to produce edible
ice. To keep the icemaker sanitary:
• Wash your hands before removing ice.
• Use the plastic scoop provided (accessory).
• Keep the scoop clean. Clean it by using a
neutral cleaner and rinsing thoroughly.
• The storage bin is for ice use only. Do not
store anything else in the bin.
• Close the door after removing ice to
prevent entrance of dirt, dust, or insects
into the storage bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
• Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
• Do not use the icemaker when you have
bare feet.
• Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
• This appliance is not suitable for
unsupervised use by young children or
aged or infirm persons.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least
3 minutes before restarting the icemaker to
prevent damage to the compressor.
5. Do not operate the unit in the "WASH"
position without water in the water tank. This
will cause damage to the water pump seal.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch, on the control box, to the
"ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply and allow the water
tank to fill with water and the icemaker to operate
for a total of 10 minutes. (See "9. Operation" for
Sequence of Operation).
6) Check the water supply and drain connections for
water leaks.
7) Turn off the power supply, and remove the front
panel.
8) Remove the insulation panel. Remove the cap
located on the front bottom part of the ice dropping
hole. Drain the water tank to flush any loose debris.
See Fig. 7.
Fig. 7
9) Replace the cap, insulation panel, and front panel
in their correct positions.
10) Clean the storage bin.
11) Turn on the power supply, and start the automatic
icemaking process.
12) Wait until a complete icemaking and harvest cycle
is completed.
Bin Control Check
1) With the front panel in place, remove the
thumbscrews along the upper edge of the storage
bin ice deflector and allow it to pivot on the side
fixings.
2) Hold some ice against the bin control bulb. The
icemaker should stop within 10 seconds.
3) Replace the thumbscrews and close the bin door.
4) Check that the icemaker re-starts.
