ENGLISH
2
* Avoid a site where dripping is not allowed.
* Do not expose the showcase to direct sunlight
or higher temperatures to prevent damage to the
plastic housing.
* Allow at least 5cm clearance between the
Condenser air inlet/outlet and the wall or other
equipment for proper air circulation. The rear
of the showcase should have enough space for
smooth operation of the Power Switch and for
easy access to the Louver and Air Filter.
* If the supply cord and the plug should need to be
replaced, it should only be done by a qualified
service engineer.
For the U.K. and the Republic of Ireland only
* The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wire in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured Green-and-Yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the
symbol
or coloured Green or Green-and-
Yellow. The wire which is coloured Blue must be
connected to the White wire in the load circuit.
The wire which is coloured Brown must be
connected to the Black wire in the load circuit.
3. SET UP
IMPORTANT
Carry the showcase by holding its bottom.
) Unpack the showcase, and remove all shipping
carton, evaporator spacer, tapes and packing
BEFORE operating the unit. Be careful not to
damage the exterior panels when handling the
showcase.
2) Position the showcase in a selected site. Clean
the interior with soap and water and rinse
thoroughly.
3) Level the showcase in both the left-to-right and
the front-to-rear directions.
4) The perimeter where the machine touches the
counter should be sealed with silicone.
4. ELECTRICAL CONNECTIONS
* This showcase must be plugged into the
separated power receptacle which has enough
capacity. The maximum allowable voltage
variation should not exceed ± 0 percent of the
nameplate rating. See the Nameplate.
Fig. 4
Air Inlet
Air Outlet
5cm
5cm
Fig. 5
Black
LOAD
White
LINE
Brown
Blue
* Should the socket outlets in the installation site
not be suitable for the plug supplied with your
product, the plug must be removed (cut off if it is
moulded on plug) and an appropriate plug fitted.
If the non-rewirable plug has been cut from the
power supply cord, it must be disposed of. There
should be no attempt to reuse it. Inserting such
a plug into a socket elsewhere presents a serious
risk of electrical shock.
* The non-rewirable plug must never be used
without a fuse cover being fitted.
The correct replacement for the detachable fuse
cover is identifiable from the manufacturer’s
reference number stamped on the plug.