January 2016
INSTALLATION
Choosing a location
The bracket must be mounted on to a strong surface, due to the weight
of the reel when full of water and the pulling action during use. Brick or
timber post surfaces are suitable.
Where possible, we recommend mounting the base of the bracket 3ft
above ground level and up to 5ft away from the faucet.
Installing the bracket
Brick Installation
Timber Installation
Tools:
Electric Drill
(hammer or rotary
), 5/16 inch
masonry drill bit, hammer, socket set (3/8 inch
socket)
Tools:
Electric Drill, 3/16 inch drill bit, socket set
(3/8 inch socket)
1.
Use the bracket to mark the 1
st
hole
position.
2.
Drill the hole with 5/16 inch masonry drill
bit, minimum 1 ½ Inches deep. (Tip: depth
is important, use sticky tape around the
drill bit to mark just over 1 ½ inch depth)
3.
Tap the yellow plug into the first hole.
4.
Now use the bracket to mark the 2
nd
hole
position, then drill hole as above and tap
the plug into the hole.
5.
Repeat process 1-3 to drill the remaining
2 holes.
6.
Set bracket in place, add the supplied
washer then screw and use the 3/8
socket to tighten.
7.
Repeat on all holes.
1.
Use the bracket to mark 4 hole positions.
2.
Drill 4 holes with 3/16 inch drill bit, 2
inches deep.
3.
Set bracket in place, add washer then
screw and use socket set to tighten.
4.
Repeat on all holes.
TIP
Ideally, mount
the reel so the
opening is at the
user’s waist
height.
