Insert the awning into brackets as shown in drawing below. Then immediately insert the
safety screw and fix it with lock not. Attachment brackets for wall and ceiling installation:
Drawing 6:
Insert awning to bracket as shown in 6.1. Fix the awning with delivered safety screw, flat
washer and nut (6.2) and tighten it properly.
In case the square tube cannot be inserted into the wall brackets, you should
slightly loosen the wall bracket screws and then try it once again. This time, move
the awning slightly forward and backwards until the bearing tube slips into the
brackets. Then immediately insert the safety screw and fix it with lock not. Use a
19 mm wrench to tighten it.
Attention! Also tighten the safety screws of wall brackets again and ensure
that they have been adequately secured.
After the awning has been mounted properly and has been adequately secured
please take away the protective band that you can find on the arm of the awning.
Otherwise it cannot be opened. Store the protective band; you can use it in future
when storing the awning.
Attention: Misplacing and misapplying the awning can cause seriously danger.
Only mount the awning yourself when you understand the mounting instructions
completely and when you are sure that the wall or ceiling you want to mount the
awning on is suitable. For your own and the safety of other people please contact
an authorized assembler for help.
Operation
The awning is already delivered with an optimally adjusted pitch angle. However, users can
adjust the screen angle within a range of 0 - 30 degrees as desired.
Adjusting the pitch angle
Side View of
Awning. Shown
Without Rain Cover
If supplied, the Rain Cover
must be fitted before fixing
Awning onto Wall Brackets
CROSS SECTION
OF WALL
CROSS SECTION
OF WALL
Retaining Nut
and Bolt
