horsch Pronto 3 - 6 DC, Руководство по эксплуатации

Страница: 93 / 129

Depth setting
The pre-emergence markers can be adjusted
in 4 stages:
•
Stage 1 - flattest position
•
Stage 4 - deepest position
1 4
.......
¾
Loosen the cotter pin (1).
¾
Set the desired level by turning the handle (2).
¾
Secure with cotter pin.
¾
Set the same stage on both pre-emergence
markers.
1
2
Pre-emergence markers
Pre-emergence markers
The pre-emergence markers mark the tram
lines before the seed grows. They can also be
subsequently mounted to the coulter brackets.
The coulter brackets are hydraulically lifted and
electrically activated by the tram line control
system.
The cutting angle of the coulter discs can be
adjusted to suit the soil conditions and the re-
quested marker depth by rotating the disc angle.
¾
Simply release the bracket and rotate the
four-cornered shaft until the requested coulter
disc angle is attained. Marking should not take
place deeper than necessary.
¾
Then tighten the screws again.
Pre-emergence markers – adapting the aggressiveness
of the disc
The pre-emergence marker can be activated or
deactivated via the terminal of the E-Manager.
¾
Follow the operating instructions for the
E-Manager, tram line rhythm section, to this end.
88 89