horsch Joker RT Series, Руководство пользователя

Страница: 37 / 50

37 | P a g e
Depth Setting – Electronic Depth Control
The depth of the machine is set by the packer and drawbar.
The position of the cylinders is controlled by the depth control module in the cab of the tractor.
NOTE: Setting should be done on firm level ground.
* Red circuit MUST be in float before operating. (This can be either a case drain or a float circuit.)
Setting:
1. Raise outside Gauge Wheels of the machine off the ground to their highest set points. (Gauge
wheels need to be lifted so they do not interfere with correctly setting the depth control.) For
further information see Gauge Wheels in the next section.
2. Turn data panel ‘ON’.
3. Lower machine 1-2 inches from the ground.
4. Press and hold the calibrate button until all read-outs read ‘0’.
5. Set the remote valve to run the wings to 40% flow.
6. Set the wing pressure by pushing the wings down with the hydraulic remote to the desired
pressure, 300-500 psi.
DO NOT EXCEED 500 PSI!
7. Select the desired depth setting.
8. Raise machine to rephrase cylinders.
9. Set the tractor lift circuit to 100% flow and set timer to 8 seconds.
10. Set the machine down using the remote timer and make sure that the actual depth reads the
same as the set depth, if not, adjust timer accordingly.
NOTE: If adjusting set point with the machine in the ground, raise the machine past set point and click
hydraulic to lower back to set point.