Horrex Resizeable UCS, Инструкция по эксплуатации

Страница: 10 / 32

12
HORREX MONTAGEHANDLEIDING
Note!
Make sure that the tape around the cassette profile and
pull bar keeps them tightly together.
Note!
Never cut through the cord! Check again to make sure
that there are no cords present in and around the
cutting area.
For customizing the width, follow steps C through I
For customizing the height, follow steps J through L
C: In preparation of shortening the cassettes, make sure they
are tied together tightly first. Wrap painters tape around
the locations where the cassettes will be cut. The cassettes
should be cut on both sides, so that the cords align in the
middle. The cassettes should, after they have been cut on
both sides, have the “cutting width” that has been calculated
with help of the table on page 11. Use the following formula to
calculate how much should be cut from either side:
cassette dimension – cutting width = ________ / 2 =
cutting size per side.
D: Measure again where the cut needs to be made and draw a
line at the right position on the painter’s tape.
E: Cut both cassettes on the right and left side on the drawn line.
Use a hacksaw and miter box for a straight result.
F: Click the cords of the blackout cassette between the two
round, portruding parts of the plastic component that is on the
back of the pull bar. Then, cross the cords, so that the cord on
the left goes to the right of the package and the cord on the
right goes to the left of the package, and click them into the
back of the pull bar guides.