10
© 2001 Directed Electronics, Inc. Vista, CA
troubleshooting
■
The current sensor does not work.
Is it programmed off? Is it programmed for five minute delay? (Refer to the
Operation Settings Learn Routine
section of this guide.)
The current sensor can sense the domelight circuit more effectively if the red (+) 12V input wire is connected
directly to the domelight positive circuit. This is not necessary in most cases, but will help when the domelight
circuit is extremely low current.
■
The shock sensor is not sensitive enough.
The mounting of the control unit is critical to shock sensor performance. If relocation of the control unit does
improve performance of the sensor, the angle of the unit and the bracket may be changed as shown below.
Remember, the siren must be protected against water damage and the more the angle is changed, the easier it
is for water to collect in the siren housing.
■
After programming, the remote does not arm and disarm the system.
Follow the instructions for transmitter/receiver learn routine carefully. (Refer to the
Transmitter/Receiver Learn
Routine
section of this guide.) The remote must be pressed three separate times in order for the system to learn
the transmitter code properly.
DRW-11
