12/18/2018 | MAN1202-01-EN
Indianapolis, USA | Cork, Ireland | Calgary, Canada | Bangalore, India | Oakleigh, Australia | Tianjin, China | Esteio, Brazil
Please visit our website for a complete listing and to learn more about certified Horner Automation products.
This document is the property of Horner Automation Group, and is subject to change.
2.1 - Port Connectors
3.1 - Installation Procedure
page 2 of 4
4.1 - Panel Cut-Out
1. Touch Screen
2. High Capacity microSD Slot
3. RS232/RS485 Serial Connector, CAN port (via RJ45), LAN Port (Ethernet)
4. USB Mini-B Port
5. Analog I/O, DC Inputs, DC Outputs
6. DC Power
2
3
5
6
4
1
The X7 utilizes a clip installation method to ensure a robust and watertight seal to the
enclosure. Please follow the steps below for the proper installation and operation of
the unit.
1.
Carefully locate an appropriate place to mount the X7. Be sure to leave
enough room at the top of the unit for insertion and removal of the
microSD™ card.
2. Carefully cut the host panel per the diagram on Page 1, creating a 174.63mm
x 130.96mm +/- 0.1mm opening into which the X7 may be installed.
If the opening is too large, water may leak into the enclosure, potentially
damaging the unit. If the opening is too small, the OCS may not fit through
the hole without damage.
3. Remove any burrs and or sharp edges and ensure the panel is not warped in
the cutting process.
4. Install and tighten the four mounting clips (provided in the box) until the
gasket forms a tight seal. For standard composite mounting clips (included with
product), use a torque rating of 2-3 in-lbs (0.23-0.34 Nm). For optional metal
mounting clips, use a torque rating of 4-8 in lbs (0.45-0.90 Nm).
5. Connect communications cables to the serial port, USB ports, and CAN
port as required.
The graphics below detail the dimensions and depth of the overall controller itself.
The X7 panel cut-out measures 6.88” (174.63mm) wide x 5.16” (130.96mm) tall.
