MAN0980-01-EN
Specifications/Installation
10/29/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, LLC. Information in this document is subject to change without notice.
Page
4
of
5
5. NETWORK DATA
Consumed Digital Data
– This data is sent from the controller to the SmartBlock. For typical applications, the I/O configuration setup in
Cscape will automatically populate this data. For more advanced applications, you may use NetPut functions to write this data. Please
see the advanced programming guide
MAN0880
for more details.
Bit
Description
1-8
Digital Outputs
Bits that control the relay or DC outputs
9-64
Reserved
65-72
Output Hold
1 = Hold on stop, 0 = Override
73-79
Reserved
80
Positive/Negative Inputs
0 = Positive Logic, 1 = Negative Logic
81-96
Reserved
97-104
Output Override Data
Output on stop when hold = 0
105-120
Reserved
Produced Digital Data
– This data is sent from the SmartBlock to the controller. Normally this data is mapped into specific registers in
the I/O configuration in Cscape. For advanced applications, NetGet functions can be used to obtain this data. Since this data is
broadcasted to all controllers on the network, additional controllers can use NetGet functions to obtain this data as well.
Bit
Description
1-8
Digital Inputs
Data from the digital inputs
9
HE579DIQ881
0 = OK, 1 = Fault on output channels 1-4
10
HE579DIQ881
0 = OK, 1 = Fault on output channels 5-8
11-32
Reserved
33-48
Status & Diagnosis Data
49-56
Firmware Version
57-64
Device Class
2
6. SETTING ID SWITCHES
CsCAN Network IDs are set using the hexadecimal number system from 01 to FD. The decimal equivalents are whole numbers 1-253.
Refer to following Conversion Table, which shows the decimal equivalent of hexadecimal numbers. Set a unique Network ID by
inserting a small flat-bladed screwdriver into the two identical switches.
NOTE:
The CsCAN Baud Rate for SmartBlock I/O is fixed at 125KBaud
