HORNER HE-XRZ2, Быстрый старт

Страница: 7 / 11

MAN0943-01 19 MAR 2007 PAGE 7
•
Make sure the unit is turned OFF before making connection to terminals. Make sure all
circuits are de-energized before making connections.
•
Before each use, inspect all cables for breaks or cracks in the insulation. Replace
immediately if defective.
1.2 FCC Compliance
The HE-XRZ2 contains a MaxStream OEM RF module
,
FCC ID: OUR-XBEEPRO The enclosed
device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (
i. ) this device may not cause harmful interference and ( ii. ) this device must accept
any interference, including interference that may cause undesired operation.
IMPORTANT:
The XBEEPRO OEM RF Module has been certified by the FCC for use with other
products without any further certification (as per FCC section 2.1091). Modifications not expressly
approved by MaxStream could void the user's authority to operate the equipment.
Effective Isotropic Radiated Power (EIRP)
IMPORTANT : Power output is conducted at the antenna terminal and can be adjusted from 10
milliwatt to 63 milliwatt at the OEM level. This is an RF module approved for Limited Modular use
operating as a mobile transmitting device with respect to section 2.1091 and is limited to OEM
installation for Mobile and Fixed applications only. During final installation, end-users are
prohibited from access to any programming parameters. Professional installation adjustment is
required for setting module power and antenna gain to meet EIRP compliance for high gain
antenna(s). Final antenna installation and operating configurations of this transmitter including
antenna gain and cable loss must not exceed the EIRP of the configuration used for calculating
MPE. Grantee (MaxStream) must coordinate with OEM integrators to ensure the end-users and
installers of products operating with the module are provided with operating instructions to satisfy
RF exposure requirements. The FCC grant is valid only when the device is sold to OEM
integrators. Integrators are instructed to ensure the end-user has no manual instructions to
remove, adjust or install the device.
FCC regulations stipulate a 20 dBm EIRP power requirement. Users implementing antenna gain
greater than 7.1 dB must compensate for the added gain with cable loss. When operating at 63
milliwatt power output, the sum (in dB) of cable loss and antenna gain shall not exceed 7.1 dB.
FCC-approved Antennas WARNING: This device has been tested with Reverse Polarity SMA
connectors. When integrated into OEM products, fixed antennas require installation preventing
end-users from replacing them with non-approved antennas. Antennas not listed in the tables
must be tested to comply with FCC Section 15.203 (unique antenna connectors) and Section
15.247 (emissions).
Fixed Base Station and Mobile Applications MaxStream RF Modules are pre-FCC approved
for use in fixed base station and mobile applica-tions. When the antenna is mounted at least
20cm (8") from nearby persons, the application is considered a mobile application.
Portable Applications and SAR Testing When the antenna is mounted closer than 20cm to
nearby persons, then the application is considered "portable" and requires an additional test be
performed on the final product. This test is called Specific Absorption Rate (SAR) testing and
measures the emissions from the module and how they affect the person.