6
BACK
4. Lay the back panel onto a soft flat surface. Lift the side panel assembly
onto the BACK (Part 5). Align all bolts and holes before loosely hand
tightening the nuts onto the bolts.
5. Place the DOOR FRAME panel (Part 6) onto the side panel assembly to
complete the exterior housing of the safe. Align all bolts and holes before
loosely hand tightening the nuts onto the bolts. After all nuts have been
loosely installed, use the included wrench and socket to tightening all
nuts.
CAUTION: Do not over tighten nuts.
6. If the inner FIRESHIELD blankets were removed in the previous steps,
replace them back into corresponding panels. The FIRESHIELD blankets
must tuck under edges to allow interior panels to fit.
7. With the safe still on its back, install the interior panels in the following
order.
WARNING: Do not force panels into place as they may crack.
a. Place the TOP INTERIOR PANEL into the safe. It may help to first insert
the front edge into the door frame before sliding the back into place.
b. Install the two SIDE INTERIOR PANEL by inserting the front edge into
the door frame before slide the back into place.
c. Finally, insert the INTERIOR BOTTOM PANEL through the door
opening between the front and back shelf strips and then drop into
position front-to-back. Make sure the lifting strap remains accessible.
8. The safe can now be stood up and moved into position. The doors can
also be reinstalled.
9. Once the safe is in its final position and you are comfortable with the
operation of the safe, bolt the safe to the floor for maximum security.
Remove the BOTTOM INTERIOR PANEL and FIRESHIELD blanket to
access the mounting holes. Use quality hardware compatible with your
particular floor type.
