7
8
How to Program Your Key Code
A single user-defined 4 to 6 digit code can be entered into the RAPiD
®
Safe Night Guard.
™
1. Open the RAPiD Safe with either the key, a previously programmed RFID tag, or key
code. The safe ships with a default code and should be reprogrammed before first use.
2. Locate the red program button to begin programming your key code. The first available
tag location will begin to blink to indicate program mode.
3. With the drawer open, enter a 4 to 6 digit code on the keypad. Press the “H” after
entering your code. Verify your code is correct by re-entering your code and pressing
“H”. The motor should cycle.
4. Your key code can now be used to open the safe.
NOTE:
Only one key code can be entered into the safe. If a second code is entered, it
will override the previous code.
**
A total of five RFID tags and one key code can be
entered into the safe.
How to Remove All Tags From Safe
1. Open the RAPiD
®
Safe with either the key, a previously programmed RFID tag, or key
code. Locate the red program button. Press and hold the button for five seconds to erase
all previously programmed tags. All five red LEDs will begin to blink in sequence. The
safe does not allow individual tags to be removed. They must all be erased at one time.
The intended RFID tags can then be reprogrammed with the instructions above.
NOTE:
To abort the erase procedure, press the “H” button on the drawer of the safe or
do not touch anything and the erase procedure will automatically abort after 10 seconds
and return to normal operation.
Test RFID tags and the key code to confirm they are
operational.
2. To confirm erasing procedure, press and release the program button again. All five LEDs
will blink three times to visually confirm all RFID tags have been removed. The RFID tags
will no longer work until they are reprogrammed with the instructions in the “How to
Program Your RFID Tags” section.
Closing the Night Guard
The safe has a latch closure sensor that will illuminate the LED in the keypad when the
drawer is closed.
Green – Latch has fully closed.
Blinking Red – Latch has NOT fully closed.
To close the safe, press the drawer in until the latch clicks. Verify green light appears on
the keypad.
USB Charging Ports
The RAPiD
®
Safe includes a USB Type A
and USB Type C charging ports on the
back of the safe.
When the RAPiD
®
Safe is plugged into AC
power with the included power supply, the
two charging ports can be used to power
common electronics.
Total Output: 5VDC 1.6A
USB Ports
Power Jack
