5
6
How to Program Your RFID Tags
Your RAPiD
®
Safe includes three (3) styles of RFID tags, including:
• 1 Wristband
• 1 Key Fob
• 2 Decals
*Additional styles can be purchased separately.
The RAPiD
®
Safe can store up to 5 tags.
To program these tags:
1. Open the RAPiD Safe with either the
key or a previously programmed RFID
tag or key code. (The safe does not
ship with pre-programmed RFID tags.
A RFID tag must be programmed to
work with this safe.)
2. Locate the red program button inside
the drawer on the back wall. Press
and release the button to begin
programming a RFID tag. The first
available program location will begin
to blink.
3.
Hold the RFID tag within 1"
of the
illuminated RFID reader area (clock
display) on the drawer front If the programming was successful, the safe should beep
two times and the available slot should go from blinking to solid red for approximately
ten seconds.
NOTE:
If the user attempts to program a RFID tag that is already stored in the safe it
will beep three times and the RFID tag will not be programmed into the duplicate slot.
The RFID tag can only be programmed into one location.
4. Verify the RFID tag is programmed by holding the tag over the clock display with the
drawer open. The motor should cycle after each scan.
5. If the RFID tag is not programmed, the program function will time out after ten seconds
and the safe will return to normal operation. If multiple attempts to program a RFID tag
fails, please contact Hornady
®
at 800-338-3220.
6. One to five RFID tags can be programmed into the safe.
Program Button
NOTE:
The RFID chip is located in the
bulge of the wristband near the clasp.
It is designed to be worn on the bottom
of the wrist for maximum read distance.
NOTE:
The RFID decal can be placed on a variety
of objects. However, metal surfaces may cause
interference and reduce the read distance. The
integrated metal housing on some cell phones
combined with potential interference from other
wireless signals such as Bluetooth, NFC, etc., may
reduce the read distance of the RFID decal.
Before adhering the RFID decal to a mobile phone,
we recommend trying different locations on the back
of the device to find the optimum read distance.
RFID Chip
RFID Decal
FPO
Placing the decal on the outside of an accessory
cover will also improve the read distance, but may
cause excessive wear, resulting in a shortened life
of the decal. When placing the decal on the inside
of an accessory cover, DO NOT face it toward the
mobile phone. The decal must face outward (away
from the phone) to work optimally.
Before placing the RAPiD Safe into service, verify
the decal works properly under various conditions
(i.e. the wireless apps on your mobile phone are on).
