HORN LHD6001+, Руководство по установке, Страница: 25 / 36

- 21 -
PROGRAMMING
Editing Installer password (command: 22XXXX)
Setting telephone ring attempts before picking- up of the panel ( command: 23X)
User’s ID (Command: 20X····X)
Note: The ID should be set with 8 digit numbers when it connected to CMS from Longhorn.
Note: Each code should be set differently for safety reasons.
.
Turning on/ off detecting siren (command: 24XY)
There will be 30 minutes for delaying after this setting. After that time, the system will be turned off this mode
if there is no operation to the system.
Note: If telephone line is used for panel and telephone, please try to set the times of calling attempts as more as possible in case
the conflict between them. After the calling attempts set, the system will be picked up and controllable by remote operation.
Note: (1) After this setting, the system will self-check the siren of the system 2 minutes later after initialization. It will report the
trouble of the siren by CID code 320.
2 Siren trouble will not be displayed in keypad, but only with beeps indication. ( )
Edit user’s password (Command: 21XYYYY)
If user's password is 8889, then the duress will be 8880, and it will be 9990 when user's password is 9999.
To restore the defaults of user's password or installer password, it can jumper the cap of RST on the PCB boards
with power disconnected in the case the user forgot the passwords. After the jumper, power the system and then
password of master or installer will be turned to defaults. Remember to take off the cap to avoid the system will be
turned to defaults again after initialization.
Setting telephone ring attempts before picking-up of the panel
(command: 23X)
Sending installing message to user or not (command: 25X)