15
EN
Warranty and Service Contact Information
FCC Information
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Antenna Separation Distance
When operating your transmitter, please be sure to maintain a separation
distance of at least 20 cm between your body (excluding fi ngers, hands, wrists,
ankles and feet) and the antenna to meet RF exposure safety requirements as
determined by FCC regulations.
This illustration shows the approximate 20 cm RF exposure area and typical
hand placement when operating your transmitter.
IC Information
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.”
IC: 6157A-EFLU4864
FCC ID: BRWEFLU4864
Country of Purchase
Horizon Hobby
Contact Information
Address
United States of America
Horizon Service Center
(Repairs and Repair Requests)
servicecenter.horizonhobby.com/RequestForm/
4105 Fieldstone Rd
Champaign, Illinois, 61822 USA
Horizon Product Support
(Product Technical Assistance)
877-504-0233
Sales
800-338-4639
EU
Horizon Technischer Service
Hanskampring 9
D 22885 Barsbüttel, Germany
Sales: Horizon Hobby GmbH
+49 (0) 4121 2655 100
20 cm
