3
EN
To register your product online, go to www.e-fl iterc.com
Installed
Motor:
8.5mm Brushed Motor
Receiver :
DSM2/DSMX 6 Ch Ultra Micro
AS3X
®
Receiver/ESC
(2) 2.3-Gram Performance Linear Long
Throw offset Servos
Needed to Complete
Recommended Battery:
300mAh 1S
3.7V 25C Li-Po
Recommended Battery Charger:
(DC)
Celectra
™
1S 3.7 Variable Rate DC
Li-Po Charger
(USB)
300mAh 1S 3.7V 25C Li-Po,
26AWG with 1S to USB Charger Adapter
Recommended Transmitter:
Spektrum
™
DSM2
®
/DSMX
®
full range
with dual-rates (DXe or DX4e and up)
17.17 in (436mm)
21.65 in (550mm)
3.30 oz
(93 g)
Transmitter and Receiver Binding ...........................4
Low Voltage Cutoff (LVC) ........................................4
ESC/Receiver Arming, Battery Installation
and Center of Gravity .............................................5
Control Direction Tests ...........................................6
Control Centering ...................................................7
Control Horn Settings .............................................7
Dual Rates .............................................................7
Landing Gear Installation .......................................8
Flying Tips and Repairs ..........................................9
Post Flight Checklist ..............................................9
Power Components Service .................................10
Troubleshooting Guide .........................................11
Limited Warranty .................................................12
Warranty and Service Information ........................14
IC Information ......................................................14
FCC Information ...................................................14
Compliance Information for the European Union ...15
Replacement Parts ..............................................55
Optional Parts ......................................................56
Decal Application .................................................57
Table of Contents
Specifi cations
Prefl ight Checklist
Wing Area: 63.80 sq in
(4.1 sq dm)
1.
Charge fl ight battery.
2.
Install fl ight battery in aircraft (once it
has been fully charged).
3.
Bind aircraft to transmitter.
4.
Make sure linkages move freely.
5.
Perform Control Direction Test with
transmitter.
6.
Perform AS3X Control Direction Test with
aircraft.
7.
Set dual rates.
8.
Adjust center of gravity.
9.
Perform a radio system Range Check.
10.
Find a safe and open area.
11. Plan fl ight for fl ying fi eld conditions.
12. Set fl ight timer for 4 minutes for fi rst
fl ight.
