3
SPEKTRUM STX2 USER GUIDE
EN
BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single
specific transmitter. The STX2™ transmitter and SPMSRX200 receiver are bound at the factory. If you need to rebind, follow
the instructions below.
SRX200 RECEIvER
Specifications
Type:
FHSS 2.4GHz protocol
Dimensions (LxWxH):
35.8 x 23.6 x 14.3 mm)
Antenna Length:
8.27 in
Channels:
2
Weight:
8.8g
Band:
2.4GHz
Voltage Range
: 3.5–9.6V
1. Insert the Bind Plug in the BIND port on the receiver.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The red LED flashes, indicating the receiver is
in bind mode.
4. Center the ST TRIM and TH TRIM dials on the transmitter.
5. Turn the steering wheel to Full Right. Power the transmitter on
while holding the steering wheel to the Right.
6. Release the steering wheel when the receiver LED stops flashing.
7. Remove the Bind Plug, then power off the receiver to save the
settings.
8. Power off the transmitter.
9. Remove the bind plug and store it in a convenient place.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle or
steering reversing has been changed.
• Binding the receiver to a different transmitter.
Your new Horizon Hobby SRX200 Receiver has a special water-resistant coating on the electronics to ensure reliable per-
formance in higher than average moisture conditions. This conformal coating can offer mild protection from light drops of water.
•
DO NOT submerge this product under water for any period of time. If it is submerged, it may result in damage or loss of
function.
•
DO NOT pour water onto or allow excess water to come in direct contact with the product.
•
DO NOT operate this product in heavy rain or snow.
•
DO NOT expose this product to salt water (ocean water or water on salt-covered roads), contaminated or polluted water.
In case of excess exposure to water or debris, immediately wipe down the SRX200 with a soft cloth, and allow it to fully dry
before next use.
NOTICE:
Never use a pressure washer to clean your vehicle.
NOTICE:
Make sure the other components in your vehicle are waterproof or water-resistant before driving in wet conditions.
Water-Resistant Component
