EN
4
LOSI
®
SUPER BAJA REY
®
2.0, SMART ESC:1/6TH 4WD RTR • INSTRUCTION MANUAL
EN
INSTALLING THE BATTERIES
TRANSMITTER FUNCTIONS
A/B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
Channel 3 Button
Throttle/Brake
Steering Wheel
Steering Rate
Adjusts the end point of the steering
Brake Rate
Adjusts the braking end point.
Steering Trim
Adjusts the steering center point. Normally, the steering trim is adjusted until the vehicle tracks straight.
Throttle Trim
Adjusts the throttle neutral point
SMART Battery Level Indicator
Servo Reversing
To reverse the Throttle (TH) or Steering (ST) channel, switch the position of the correlating switch—
“N” is for normal, “R” is for reverse.
Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving the vehicle in a small area.
Power LED
• Solid red lights:
Indicates radio connectivity and adequate battery power
• Flashing red lights:
Indicates the battery voltage is critically low. Replace batteries
Power Button
Bind Button
This transmitter requires 4 AA batteries
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION:
Never remove the transmitter batteries while the model is powered
ON. Loss of model control, damage, or injury may occur.
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries.
Charging non-rechargeable batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose
of used batteries according to national regulations.
TRANSMITTER BATTERY INSTALLATION
C
D
H
J
K
L
I
G
F
E
M
N
A/B
1. Ensure the ESC is powered OFF.
2. Pull the battery door release to release the battery cover.
3. Remove the battery cover.
4. Install fully charged batteries into the vehicle.
TIP:
Run the battery plugs out through the plug hole in the battery compartment.
5. Connect the batteries to the ESC.
6. Re-install the battery cover, snapping it into place. Verify the battery door release is
fully seated.
7. Power ON the transmitter, then the vehicle.