EN
4
LOSI
®
22S NO PREP DRAG: 1/10 SCALE 2WD RTR • INSTRUCTION MANUAL
INSTALLING THE BATTERY
INSTALLING THE TRANSMITTER BATTERIES
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries. Charg-
ing non-rechargeable batteries may cause the batteries to burst, resulting in injury to
persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to national regulations.
CAUTION:
Never remove the transmitter batteries while the model is powered ON.
Loss of model control, damage, or injury may occur.
1. Ensure the ESC is powered OFF.
2. Remove the body clips and lift the vehicle body.
3. Remove the elastomer straps from the battery posts.
4. Install the fully charged battery in the vehicle.
5. Resecure the elastomer straps.
6. Connect the battery to the ESC noting the correct polarity.
7. Power ON the transmitter, then the vehicle.
A. Throttle Trim
Adjusts the throttle neutral point
B. Steering Trim
Adjusts the steering center point. Normally, the steering trim is adjusted until the vehicle tracks
straight.
C. LED
• Solid red lights:
Indicates the power is ON and adequate battery power
• Flashing red lights:
Indicates the battery voltage is critically low. Replace batteries
D. Steering Wheel
E. Throttle/Brake
F. Steering Rate
On-The-Fly knob for travel adjustment on the steering
G. Channel 3
3 position momentary switch, middle position is neutral
For programming press up for A button, press down for B button
H. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving the vehicle in a small
area.
I. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
J. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
K. Power Button
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
A
B
C
D
E
F
G
H
I
J
K
Specifications
Power Supply:
4 AA Batteries
Operating Frequency:
2.4GHz
Transmit Power:
<100mw
Control Protocol:
SLT
Control:
Proportional Steering and Throttle/Brake with Trim Knobs, Third Channel with 3 Position
Momentary Switch
Auxiliary Functions:
3 Position Throttle Limit Switch, Steering Rate Knob to Change Steering
Travel on-the-fly, Programmable Servo Travel for Steering and Throttle/Brake
TRANSMITTER FUNCTIONS
