5
EN
DBXL
™
2.0 GAS RTR: 1:5 4WD DESERT BUGGY • INSTRUCTION MANUAL
TRANSMITTER FUNCTIONS
A. Throttle Trim
Adjusts the throttle neutral point
B. Steering Trim
Adjusts the steering center point. Normally, the steering trim is adjusted until the vehicle
tracks straight.
C. LED
• Solid red lights:
Indicates the power is ON and adequate battery power
• Flashing red lights:
Indicates the battery voltage is critically low. Replace batteries
D. Steering Wheel
E. Throttle/Brake
F. Steering Rate
On-The-Fly knob for travel adjustment on the steering
G. Channel 3
3 position momentary switch, middle position is neutral
For programming press up for A button, press down for B button
H. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving the vehicle in a
small area.
I. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
J. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
K. Power Button
A.
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
Specifications
Power Supply:
4 AA Batteries
Operating Frequency:
2.4GHz
Transmit Power:
<100mw
Control Protocol:
SLT
Control:
Proportional Steering and Throttle/Brake with Trim Knobs, Third Channel with 3 Position Momentary Switch
Auxiliary Functions:
3 Position Throttle Limit Switch, Steering Rate Knob to Change Steering Travel on-the-fly,
Programmable Servo Travel for Steering and Throttle/Brake
SERVO TRAVEL
T
he servo travel on the Steering and Throttle channels can be adjusted through a
special programming mode in the transmitter.
1. Begin with the transmitter binding process to the receiver complete. Power
ON the receiver.
2. Hold full right and full brake while powering the transmitter ON to put the
transmitter into programming mode.
The LED on the transmitter will flash 4 times to indicate it is in program-
ming mode.
3. Turn and hold the wheel full left to set the travel limit for that direction,
Press the A button to increase travel, press the B button to reduce travel.
The LED will flash once with every change. Return the wheel to center to
set the travel value.
IMPORTANT:
If the value has reached the maximum or minimum that can be accepted,
the LED will not flash with further input.
4. Turn the wheel to the right and repeat the process to set the steering travel
to the right.
5. For electric vehicles, power the Transmitter OFF to save the settings. Cali-
brate your ESC to the default throttle travel.
6. For fuel powered vehicles, set the throttle travel without the engine run-
ning; After setting steering travel, you can set throttle travel with the same
process. Pull and hold full throttle, adjust travel with the A and B buttons,
return to center to set the value.
7. Push full brake, adjust travel with the A and B buttons, return to center
8. Power the transmitter OFF to save the values.