EN
Wing Assembly
1. Align the wing with the wing saddle on the fuselage.
2. Verify the servo connections and bolt holes on the wing are aligned with those
in the fuselage. Do not force the wing in place.
3. Verify the servo connections are mating properly and allow the wing to drop in
place before tightening the wing bolts.
4. Locate the bolt holes through the wing with the five 3mm x 32mm counter sunk
machine screws. Thread each of the wing bolts only a few threads into the wing
saddle until all are started.
5. Tighten the wing bolts alternaternating from side to side until they are snug.
Model Assembly
Continued
5
Receiver Installation
(PNP)
The Spektrum AR636 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 6-channel full range (sport)
receiver. Refer to your receiver manual for correct installation and operation
instructions.
Installation
(AR636 shown)
1. Mount the receiver parallel to the length of the fuselage as shown. Use heavy
duty double-sided servo tape.
NOTICE:
Incorrect installation of the receiver could cause a crash.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.
AR636 Port Assignments
BND/PRG = BIND
1 = Throttle
2 = Ailerons
3 = Elevator
4 = Rudder
5 = Retracts
6 = Flaps
