EN
11
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing at the
root. This CG location has been determined with the recommended
Li-Po battery (SPMX22004S30).
Tip:
Measure the CG with the aircraft inverted.
NOTICE:
Install the battery but do not connect the ESC while
checking the CG. Personal injury may result.
AS3X Control Direction Test (BNF Basic)
This test ensures that the AS3X
®
control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
CAUTION:
Keep all body parts, hair and loose clothing away from
a moving propeller, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces
move in the direction indicated in the graphic. If the control surfaces
do not respond as shown, do not fl y the aircraft. Refer to the receiver
manual for more information.
Once the AS3X system is active, control surfaces may move rapidly.
This is normal. AS3X remains active until the battery is disconnected.
Aircraft
movement
AS3X Reaction
Elev
ator
Aileron
Rudder
back from leading edge
of wing at the fuselage.
90 –100 mm +/- 3mm
During your fi rst fl ight, trim the aircraft for level fl ight at 3/4 throttle. Make small trim
adjustments with your transmitter’s trim switches to straighten the aircraft’s fl ight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This allows the receiver
to learn the correct settings to optimize AS3X performance.
Failure to do so could affect fl ight performance.
In Flight Trimming (BNF Basic)
3 Seconds
