EN
Ultrix 600mm
6
The CG location is
290mm
back from the nose, which was determined with the recommended battery at the front of the
battery tray.
-
Sport Flying Battery Location:
Install the battery in the front of the battery compartment.
-Extreme 3D Location:
Install the battery so that the back edge of the battery is aligned with the front
edge of the battery hatch opening.
290mm
For subsequent flights, power on the transmitter for 5 seconds before connecting the flight battery.
Battery Placement and Center of Gravity (CG)
Transmitter and Receiver Binding
Sport Flying
Extreme
3D Flying
LED Indicator on Receiver
Waiting to Bind
Fast Blue flashing and fast red flashing
Connected, throttle not at zero
Red and Blue Solid
SAFE Mode
Blue Solid
AS3X Mode
Red Solid
Low Voltage Cutoff
Red Flashing
Binding Procedure
1. Refer to your transmitter manual for instruction on binding the transmitter to a receiver.
2. Ensure the flight battery is not connected to the aircraft.
3. Depending on your transmitter, either power off the transmitter or ensure the RF signal is off.
4. Connect the flight battery in the Aircraft. The LEDs will begin flashing fast, the LED will flashing blue and red
indicating the receiver is in bind mode.
5. Make sure the transmitter controls are at neutral and the throttle and throttle trim are in the low position.
6. Place the transmitter in bind mode. Refer to your transmitter manual for binding instructions.
7. After 5-10 seconds, the receiver will connect and the motor will arm. If you encounter problems refer to the
Troubleshooting Guide
at the back of the manual.
